Air scrubber clogging: venturi, cyclone, packed bed scrubbers

Accumulation of unwanted materials — clogging and fouling — is detrimental to the working function of a scrubber: it disrupts its working cycle, leads to complications and more frequent maintenance. The clogging of an air scrubber occurs due to the high particulate matter (PM) concentrations in the gas that is being treated. Over time PM accumulates on the surface of the scrubber leading to less efficient air scrubbing and overall system failure.

Most modern air scrubbers suffer from clogging and other detrimental effects of high PM concentrations. Often clogging is a result of certain design aspects — the way inlet gas enters and exits the scrubber, cleaning liquid introduction and discharge, etc.

Venturi wet air scrubbers are prone to clogging of the throat, which is the narrowest part of the scrubber, and solids buildup on the rods. Gas moving at high velocities forms small droplets necessary for the collection of the particles. Buildup removal is problematic as venturi scrubber throats are difficult to access. Besides clogging, venturi wet air scrubbers suffer from corrosion of its surfaces from exposure to the high-velocity gas.

The main maintenance problem of cyclonic spray scrubbers is clogging of nozzles through which a cleaning liquid is introduced and scrubbed gas enters and exits. This problem can not be eradicated completely; to minimize the effects of particulate matter buildup the installation of easily accessible nozzles is recommended. Similar to the venturi scrubbers, erosion of side walls of the cyclonic spray scrubbers is also a problem.

Packed bed scrubbers possess significant limitations because of their design: these scrubbers are not suitable for high concentrations of PM and high dust loading as the packed bed clogs easily. Packed bed scrubbers are the hardest of all air scrubbers to clean as packing material is often very fine and hard to access.

Air scrubber clogging and solids buildup is a serious issue that is often hard or even impossible to eradicate. Unlike conventional wet air scrubbers, a Multi-Vortex wet air scrubber does not clog because of its unique design. Within a Multi-Vortex wet air scrubber no abrasion or corrosion of the surfaces happens, therefore core components of a Multi-Vortex wet air scrubber can be made out of plastic; these components do not have to be replaced.

If you search for the best air treatment device to improve air quality, you can buy a high-tech completely new type of wet scrubber – a Multi-Vortex wet air scrubber produced by Redwood Technology.

Redwood technology is a fast-growing vendor of wet air scrubbers. The multi-vortex scrubber can remove gas emissions, dust, vapors, and other pollutants from a gas stream. It is an innovative technology created to save water that makes it more cost-efficient and differs from other types of scrubbers.  If you have any questions or would like to purchase a multi-vortex wet air scrubber, please contact us at


Air scrubber clogging: venturi, cyclone, packed bed scrubbers


Leave a Reply

Your email address will not be published.